GSP8 Sander Polisher

Gemmasta GSP8 Sander/Polisher

This Australian Made unit is constructed of aluminium alloy casting, stainless steel shaft and heavy duty bearings. Gemmasta machines are finely engineered and made in Ballina, NSW.

It is supplied with the following:

• 200mm (8 Inch) Machined Aluminium Face Plate. 
• Marine carpet in the tray to prevent damage to stones if they come off the dop or out of your fingers.
• Supplied on an epoxy sealed board with a 1/3 hp motor.
• Base board is 50x45cm there is no longer motor overhang as seen in above images.

Please note:

Safety glasses should be worn when grinding and polishing with any abrasives!

Stone dusts as well as organic material dusts can be very hazardous. Protective breathing equipment such as a face mask should be used to protect your lungs. Good ventilation is also highly recommended.

RPM: 600

All machines before the 17/06/25 or serial number #1769 or ealier have a 5/8 Right Hand thread on their shaft. 
All machines made from the 17/06/25 with #1770 onward have 5/8 Left Hand thread that now spins clockwise.